Need help?Do you have a question about the EAT C-Sharp and is the answer not in the manual?
General| Drive Principle | belt drive |
|---|---|
| Speed variance | ±0.1% |
| Effective arm length | 230 mm |
| Power consumption | 5 W |
| Speeds | 33, 45 RPM |
| Signal to Noise | 70 dB |
| Output | RCA |
Instructions for removing transport screws prior to installation.
Guidance on removing protective covers and installing the sub-platter and drive belt.
Steps for installing the platter onto the sub-platter.
Detailed steps for assembling and setting up the tonearm components.
Procedure for installing the cartridge into the headshell.
Instructions for assembling the tonearm counterweight and its parts.
Method for setting the vertical tracking force using the counterweight and gauge.
How to connect the tonearm output cable to the turntable.
Procedure for adjusting the vertical tracking angle of the tonearm arm pillar.
Steps for correctly setting the tonearm azimuth for accurate groove tracing.
Instructions for assembling and adjusting the anti-skating mechanism.
How to ensure the turntable is perfectly level using adjustable feet.
Guide to starting the motor and selecting playback speeds (33/45 RPM).
Common issues, potential incorrect uses, and troubleshooting steps for the turntable.
Guidance on seeking service and details regarding warranty conditions and repairs.
To Next Page
