Eaton 5125 Replacement Manual

1000 - 2000 VA
User’s Manual
1019297
Revision A
18
Use the following procedure to replace internal batteries:
1. Remove the UPS front panel by pulling the top.
2. Slide up and remove the metal battery cover.
3. 1000 VA units. Disconnect the red battery cable on the front of the battery. Pull the
battery out onto a flat, stable surface. Disconnect the black battery cable on the rear
of the battery, then on the front of the battery. Disconnect the red battery cable on
the rear of the battery. See “Recycling the Used Battery” on page 20 for proper
disposal.

Eaton 5125 Specifications

General

Number of Outlets	8
Form Factor	Tower
Topology	Line-Interactive
Output Voltage Regulation	± 5%
Input Frequency	50/60 Hz
Output Frequency	50/60 Hz
Outlets	8 NEMA 5-15R
Communication Ports	USB, Serial
Typical Backup Time at Full Load	5 minutes
Efficiency	up to 95%
Frequency	50/60 Hz
Battery Type	Sealed Lead Acid