Eaton
®
setUPS
Firmware upgrade procedure
Eaton®setUPS_5PX_firmware_upgrade_rev_02 Page 9/14
7. Confirmation
The following screen appears which reminds you that UPS output is OFF during the
upgrade, select “Yes” to continue
8. Upgrade process
A click noise comes from the UPS (relay) and it transfers into Boot loader mode. The
firmware will then be erased and then rewritten into the UPS.
During the flash process, the display on the UPS goes blank and the AC line, the battery
and the Alarm lights cycle. This is normal.
To Next Page
Loading...
