INSTALLATION
Eaton
®
9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality
18
Unpacking the Cabinet
C
A U T I O N
S Unpacking the cabinet in a low-temperature environment may cause condensation to
occur in and on the cabinet. Do not install the cabinet until the inside and outside of the
cabinet are absolutely dry (hazard of electric shock).
S The cabinet is heavy (see page 78). Use caution to unpack and move the cabinet.
Use care when moving and opening the carton. Leave the components
packaged until ready to install.
To unpack the cabinet and accessories:
1. Open the outer carton and remove the accessories packaged with
the cabinet.
2. Carefully lift the cabinet out of the outer carton.
3. Discard or recycle the packaging in a responsible manner, or store it
for future use.
Place the cabinet in a protected area that has adequate airflow and is
free of humidity, flammable gas, and corrosion.
Checking the Accessory Kit
Verify that the following additional items are included with the UPS:
S UPS user's guide
S Quick start instructions
S Software Suite CD
S USB cable
S Power cord (for models without an attached power cord)
If you ordered an optional Extended Battery Module (EBM), verify that
the following additional item is included with the EBM:
S EBM user's guide
NOTE Discard the EBM user's guide if you are installing the EBM with a new UPS at the
same time. Use the UPS user's guide to install both the UPS and the EBM.
To Next Page
Loading...
Need help?
General
