Eaton 9130 UPS User Manual

Eaton
®
9130 UPS (700–3000 VA) User's Guide S 164201718 Rev 3 www.eaton.com/powerquality
53
Chapter 5 Communication
This section describes the:
S Communication ports (RS-232 and USB)
S Connectivity cards
S Remote Emergency Power-off (REPO)
S Relay output contacts
S Programmable signal inputs
S Modem operation
S LanSafe
®
Power Management Software
Figure 18 shows the location of the communication options and control
terminals on a typical UPS.
See “Rear Panels” on page 91 for rear panel diagrams for each model.
Communication Bay USB REPO
RS-232 Standard Relay Output Contact
Output Input
Figure 18. Communication Options and Control Terminals (PW9130L1000R-XL2U Model Shown)

Eaton 9130 UPS Specifications

General

Transfer Time	0 ms
Waveform Type	Sine wave
Output Voltage	200/208/220/230/240V
Input Voltage Range	160-294V (adjustable to 140-300V)
Frequency Range	50/60 Hz ± 3 Hz (auto sensing)
Efficiency	Up to 95%
Form Factor	Rack/Tower Convertible
Battery Type	Sealed, lead-acid
Communication Interface	USB, RS-232, Relay
Typical Recharge Time	3 hours
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-15°C to 45°C (5°F to 113°F)
Relative Humidity	0% to 95% (non-condensing)
Safety Approvals	UL, cUL, CE