Eaton 93PM-50-1 - Page 43

Eaton 93PM Emergency Lighting UPS (50 kW, 480V Three and Four-Wire UL 924) Installation and Operation Manual P-164000569—Rev 03 33
Figure 14. Removing the Sidecar Rear Shipping Bracket – Eaton 93PM UPS
Rear Shipping
Bracket
44..33 IInntteeggrraatteedd BBaatttteerryy CCaabbiinneett IInnssttaallllaattiioonn
If installing Integrated Battery Cabinets (IBCs), refer to the Eaton 93PM Integrated Battery Cabinet Installation
Manual-Large and Large High Rate, the Eaton 93PM Universal Integrated Battery Cabinet Installation Manual-
Large and Large High Rate, Eaton 93PM Integrated Battery Cabinet Installation Manual-Small, or the Eaton
93PM Integrated Battery Cabinet Installation Manual-Small Welded, listed in paragraph
1.8 For More Information, for installation instructions.
After the IBC is installed, proceed to paragraph
4.4 Sidecar Integrated Accessory Cabinet-Bypass Wiring Installation if a Sidecar Integrated Accessory Cabinet-
Bypass (SIAC-B) is attached to the UPS.
44..44 SSiiddeeccaarr IInntteeggrraatteedd AAcccceessssoorryy CCaabbiinneett--BByyppaassss WWiirriinngg IInnssttaallllaattiioonn
If an SIAC-B is attached to the UPS, refer to the Eaton 93PM Sidecar Integrated Accessory Cabinet-Bypass
Installation and Operation (50 kW and 100 kW SIAC-B) Manual, listed in paragraph 1.8 For More Information, for
wiring installation instructions.
After the SIAC-B is wired, proceed to paragraph 4.5 External AC Power Wiring Installation to complete the
wiring of the UPS.
44..55 EExxtteerrnnaall AACC PPoowweerr WWiirriinngg IInnssttaallllaattiioonn
To install wiring:
1. Open the front door by lifting the latch from the bottom and turning to the right (counterclockwise) and
swing the door open.
UPS System Installation