What does it mean when no battery LED is on and the Eaton 9PX10KSP UPS beeps continuously?
The batteries are disconnected. Verify that all batteries are properly connected. If the condition persists, contact your service representative.
Why does my Eaton UPS not start?
The input source may not be connected correctly, so check the input connections. Alternatively, the Remote Power Off (RPO) switch may be active, or the RPO connector is missing. If the UPS Status menu displays the 'Remote Power Off' notice, inactivate the RPO input.
What does it mean when the battery fault LED is on and the Eaton UPS beeps continuously?
The battery test has failed due to bad or disconnected batteries, or the battery minimum voltage is reached in ABM cycling mode. Verify that all batteries are properly connected and start a new battery test. If the condition persists, contact your service representative.
Why is the bypass mode LED on for my Eaton 9PX10KSP UPS?
An overload or fault has occurred, or a command has been received, and the UPS is in Bypass mode. This means your equipment is powered but not protected by the UPS. Check for overtemperature, overload, or UPS failure alarms.
What to do if the Eaton 9PX10KSP overtemperature LED is on and beeping?
The UPS internal temperature is too high or a fan has failed. If the UPS transferred to Bypass mode, it will return to normal operation when the temperature drops 5°C below the warning level. If the condition persists, shut down the UPS, clear vents, remove any heat sources, and ensure airflow is not restricted. Restart the UPS, and if the condition continues, contact your service representative.
Why doesn't my Eaton 9PX10KSP UPS provide the expected backup time?
The batteries may need charging or servicing. Apply utility power for 48 hours to charge the batteries. If the problem persists, contact your service representative.
Why is the battery mode LED on and the Eaton UPS beeping every 10 seconds?
A utility failure has occurred, and the Eaton UPS is running in Battery mode. The UPS is powering your equipment with battery power, so prepare your equipment for shutdown.
To Next Page
General
