What to do if the MBP is disconnected from my Eaton 9SX 5000?
The HotSwap MBP is no more connected to the UPS. If the HotSwap MBP is connected to the UPS, check that the detection connector is correctly plugged.
General| Power Rating | 5000 VA |
|---|---|
| Output Power | 4500 W |
| Form Factor | Tower |
| Topology | Double Conversion Online |
| Output Frequency | 50/60 Hz |
| Frequency Range | 40 - 70 Hz |
| Operating Temperature | 0 - 40 °C |
| Input Voltage | 200-240 V |
| Output Voltage | 200-240 VAC |
| Battery Type | Lead-acid battery |
| Communication Ports | USB, RS-232 |
| Input Frequency | 50/60 Hz |
| Typical Recharge Time | 3 hours to 90% |
Lists the safety and EMC certification standards the UPS complies with.
Step-by-step guide for powering the UPS on and off correctly.
Indicates when battery replacement is recommended based on UPS status.
Procedure for replacing Extended Battery Modules (EBMs) safely.
Steps to conduct a battery test after installation or replacement.
Chart for identifying UPS conditions, possible causes, and recommended actions.
To Next Page
