I.L.15.01.T.K. Page 19
Effective June 2000
corrosion and any excessive wear on
the mechanical operating parts. Clean,
lubricate or re-place parts where
necessary.
6. Check all adjustable control components
(time delay and voltage sensing relays)
for correct settings.
7. If the horizontal mechanism is removed
be sure that the scribe lines on the
gears are in line. When re-assembling
the drive mechanisms, be sure that they
are fastened to the correct holes in the
frame and that the breaker handles are
between the cam fingers. (One breaker
has to be on and the other off.)
To Next Page
Loading...
