I.L.15.01.T.K. Page 7
Effective June 2000
5. Performance Specifications
The performance specifications for the ATS-MP1 Controller Board are given in Table 2:
Table 2 – Performance Specifications
Input Control Voltage (50-150)% of V
(IN,RMS)
50/60 Hz
Voltage Measurements of: Normal Source V
AB
Normal Source V
BC
Normal Source V
CA
Emergency Source V
AB
Emergency Source V
BC
Emergency Source V
CA
Voltage Measurement Range: 0 to 360 VAC RMS (50/60Hz) – MP1
0 to 750 VAC RMS (50/60Hz) – MP1-E
Voltage Measurement Accuracy:
± 2% of reading over the monitoring range
Frequency Measurements of: Normal Source (S1), Emergency Source (S2)
Frequency Measurement Range: 40 Hz to 70 Hz
Frequency Measurement Accuracy
± 0.3 Hz over the measurement range
Undervoltage Dropout Range: 50% to 97% of the nominal system voltage
Undervoltage Pickup Range: (Dropout +2%) to 99% of the nominal system voltage
Overvoltage Dropout Range: 105% to 120% of the nominal system voltage
Overvoltage Pickup Range: 103% to (Dropout –2%) of the nominal system voltage
Underfrequency Dropout Range: 90% to 97% of the nominal system frequency
Underfrequency Pickup Range: (Dropout + 1Hz) to 99% of the nominal system frequency
Overfrequency Dropout Range: 103% to 110% of the nominal system frequency
Overfrequency Pickup Range: 101% to (Dropout – 1Hz) of the nominal system frequency
Operating Temperature Range
-20°C to + 70°C
Storage Temperature Range
-35°C to + 85°C
Operating Humidity 0 to 95% relative humidity (non-condensing)
Generator Start Relay 5A, 1/6 HP @ 250VAC
5A @ 30VDC with a 30W maximum load
Alarm Relay 10A, 1-3 HP @ 250VAC
10A @ 30VDC
Table 3 - Applicable Test Standards
UL 991
Canadian Standards Association Conformance (CSA)
UL 1008 / CSA 22.2 No 178.22
Dielectric test
FCC Part 15
Conducted/Radiated Emissions (Class A)
CISPR 11
Conducted/Radiated Emissions (Class A)
IEC 1000-2
Electrostatic Discharge test
IEC 1000-3
Radiated Susceptibility tests
IEC 1000-4
Fast Transient tests
IEC 1000-5
Surge Withstand tests
To Next Page
Loading...
