Application Note Establish Ethernet connection between easyE4 and easySoft V7 04/2020 AP050013ENEN www.eaton.com 23
NOTE: The integrated PC interface is selected by default. In case of multiple interfaces, the
selection is not saved when you close the window and must be selected again next time.
8. Search for new devices.
9. The connected easyE4 device type is displayed with the corresponding IP address.
10. The Ethernet settings of the easyE4 are read in. For a new device, "Auto IP" is set, as this is
the factory setting. Change the IP settings to "DCHP".
11. The option "Enable configuration via network" is enabled for the easyE4 in the factory set-
ting.
NOTE: This release is given as a factory setting in the device (ticked) to enable the transfer of
the desired IP settings to the easyE4.
12. Transfer the changed IP settings to the easyE4 by clicking on "=> Device". A new IP address
assigned to the easyE4 by the DCHP server is displayed in the search window.
13. Go to "Save as IP profile" to save the connection profile.
14. Close the window.
15. The IP address of the easyE4 is offered for selection under "Interface".
16. Go to „Online“.
17. The easyE4 to which you are now connected is displayed on the work pane.
18. Transfer your project by clicking on "PC => Device".
To Next Page
Loading...
