24 Application Note Establish Ethernet connection between easyE4 and easySoft V7 04/2020 AP050013EN www.eaton.com
NOTE: When downloading the *.e70 project, the IP settings from the register "Ethernet" (view
"Project") are transferred to the easyE4. Depending on how these are set (i.e. different from
those in the IP profile currently used for the connection), the Ethernet connection to the
easyE4 is terminated immediately after downloading the *.e70 project. If you would like to
establish a new connection, create an IP profile as interface with the previously transferred IP
settings.
19. Start the program by clicking on "RUN".
To Next Page
Loading...
