Eaton ELC-PB - Page 93

ELC Programming Manual
FOR MORE INFORMATION VISIT: WWW.EATON.COM MN05003003E
2-64
Special D
Function
ELC
-PB
ELCB
-PB
ELC
-PC
-PA
-PH
ELCM
-PH
- PA
ELC
-PV
OFF
Ø
ON
STOP
Ø
RUN
RUN
Ø
STOP
Type Latched
Factory
setting
D1219
End latched address of register
D2000~D4999
- Y - Y - - - R/W Yes 4999
D1220
Phase of the 1st group pulse output
CH0 (Y0, Y1)
- - Y Y 0
- - R/W NO 0
D1221
Phase of the 2nd group pulse output
CH1 (Y2, Y3)
- - Y Y 0
- - R/W NO 0
D1222
Time difference between direction
signal and pulse output for the 1st
group pulse CH0 (Y0, Y1) in DRVI,
DDRVI, DRVA, DDRVA, PLSV, DPLSV
- - - Y 0
- - R/W NO 0
D1223
Time difference between direction
signal and pulse output for the 2nd
group pulse CH1 (Y2, Y3) in DRVI,
DDRVI, DRVA, DDRVA, PLSV, DPLSV
- - - Y 0
- - R/W NO 0
D1225
Counting mode of the counter HHSC0
- - - Y 2
- - R/W NO 2
D1226
Counting mode of the counter HHSC1
- - - Y 2
- - R/W NO 2
D1227
Counting mode of the counter HHSC2
- - - Y 2
- - R/W NO 2
D1228
Counting mode of the counter HHSC3
- - - Y 2
- - R/W NO 2
D1129
Phase of the 3rd group pulse output
CH2 (Y4, Y5)
- - - Y 0
- - R/W NO 0
D1130
Phase of the 4th group pulse output
CH3 (Y6, Y7)
- - - Y 0
- - R/W NO 0
D1232
Output pulse number for ramp-down
stop when CH0 mark sensor receives
signals. (Low Word).
- - Y Y 0 - - R/W NO 0
D1233
Output pulse number for ramp-down
stop when CH0 mark sensor receives
signals. (High Word).
- - Y Y 0 - - R/W NO 0
D1234
Output pulse number for ramp-down
stop when CH1 mark sensor receives
signals (Low Word).
- - Y Y 0 - - R/W NO 0
D1235
Output pulse number for ramp-down
stop when CH1 mark sensor receives
signals (High Word).
- - Y Y 0 - - R/W NO 0
D1236
Output pulse number for ramp-down
stop when CH2 mark sensor receives
signals (Low Word)
- - - Y 0 - - R/W NO 0
D1237
Output pulse number for ramp-down
stop when CH2 mark sensor receives
signals (High Word)
- - - Y 0 - - R/W NO 0
D1238
Output pulse number for ramp-down
stop when CH3 mark sensor receives
signals (Low Word)
- - - Y 0 - - R/W NO 0
D1239
Output pulse number for ramp-down
stop when CH3 mark sensor receives
signals (High Word)
- - - Y 0 - - R/W NO 0
D1240
When interrupt I400/I401/I100/I101
occurs, D1240 stores the low Word of
high-speed counter.
- - Y - 0 0 - R
NO
0
D1241
When interrupt I400/I401/I100/I101
occurs, D1241 stores the high Word of
high-speed counter.
- - Y - 0 0 - R
NO
0