Eaton i-on40H - Call Mode; Messages

Test Menu
Page 111
If the control unit has Call Acknowledge enabled (see page 112), the person receiving the
speech messages can control the link by sending DTMF tones back to the control unit
(usually by pressing buttons on the telephone key pad). The commands available are:
Function
Key
End this call
DTMF ‘5’
Play ‘Home’ and ‘alarm’ message
DTMF ‘3’
Clear down
DTMF ‘9’
Note that when the called party answers a speech dialler call, there could be a six-second
delay before the control unit starts playing the home message.
Call Mode
This option enables or disables the speech dialler feature.
Messages
Use this option to record the speech messages you wish the speech dialler to use.
There are five messages slots available: The Home Message and Messages 1 to 4. The
i-sd02 and i-gsm02 plug-in module can record up to ten seconds of speech for the Home
message, and up to five seconds of speech for each of the alarm messages. Within each
message, you can use any of the following options:
Record Message
Press  to start recording. The control unit starts recording from the module's built-in
microphone. The display shows a progress bar indicating how long you have left to
record. Press  to end recording.
Play Message
Press  to play back the message from the module's speaker.
Delete Message
Press  to delete the message. When the display asks “Delete Message?” press .
Use Lid Tamper
This puts the control unit into a special mode where the tamper switch controls the
recording and playback of the current message. Use this mode if the control unit is
an inconvenient distance from the keypad.
1. Start with the control unit lid off and the tamper switch open.
2. At the keypad select Use Lid Tamper and press .
3. At the control unit hold down the tamper switch. When the red LED on the plug-
in module glows, recite your message.
4. Release the tamper switch.
5. Pulse the tamper switch briefly. The plug-in module plays back your recording.
6. Go back to the keypad and press .
7. If required, replace the control unit lid. DO NOT replace the control unit lid until
you have left the “Use Lid Tamper” mode.