Eaton i-on40H - Downloader and the Log; Logging Tamper Events; Logging Software Updates

Test Menu
Page 131
action.
User 057
Virtual Keypad - displayed when the Virtual Keypad carries out an
action.
User 060
SMS control - displayed when the SMS control carries out an
action.
User 061
App control - displayed when the App carries out an action.
Note: The word “Web” appears in the log entry if the installer logged on using the web
browser.
Downloader and the Log
When Downloader connects to a control unit, the control unit logs the event as “Rem
Download”. This indicates that Downloader successfully connected and disconnected.
The control unit logs a separate event “Unn Config Change” if Downloader changes the
configuration of the control unit. The user number recorded will be that for the Downloader
(see table above).
Logging Tamper Events
Tamper events are normally logged. However please note that the type of events that are
considered to be tampers depends to some extent on the options the Installer chooses in
System Options – Jamming and System Options – Supervision (see page 95). When
these options are set to “Tamper” then jamming or supervision failure events will be
recorded as tampers.
Logging Software Updates
The control unit logs the software version every time the system starts up from zero power.
To see the software version press  or  when the keypad displays the log message
“System Startup”.