Eaton i-on40H Engineering Guide

Log Messages
Page 142
U-- Log On Remote
M2M, SMS Control or virtual
keypad logon.
U-- Off-Site (Web)
User nn logged out of Installer
Menu from web server.
U-- Off-Site
User nn left Installer mode.
U-- On-Site (Web)
User nn logged into Installer Menu
from web server.
U-- On-Site
User nn entered Installer mode.
U-- Ptn # Override
User nn overrode set fail at
partition.
U-- Ptn # Override
User nn overrode set fail at
partition.
U-- Ptn # PtSet
User nn part set partition.
U-- Ptn # Reset
User nn reset partition.
U-- Ptn # Set
User nn set partition.
U-- Ptn # Unset
User nn unset partition.
U--- Ptn ## Dur Rs
User nn keyed in a Duress code to
unset partition n.
U--- Ptn ## Duress
User nn keyed in a Duress code to
set partition n.
U--- Ptn ## Exit
User nn started the exit process
for full set on partition n.
U--- PtSet # Exit
User nn started the exit process
for part set on partition n.
U-- Rem Download
Downloader session completed
successfully.
U-- Set Override
User nn overrode set fail.
U--- Shunt Code
User n Shunt code used.
U-- Spch Tel = Chg
User changed speech dialler
telephone number.
U--- System Exit
User nn started the exit process
for full set on a part setting
system.
U-- System PtSet #
User nn part set system.
U-- System Reset
User nn reset system.
U-- System Set
User nn set system.
U-- System Unset
User nn unset system.
U-- Time/Date
User nn changed time and/or date.
U-- Z== Omit
User nn omitted zone.
U--- Z=== HUA Omit
User nn omitted Hold Up Alarm
zone nn.
U--- Z=== Omit Rst
User nn included Hold Up Alarm
zone nn.
U--- Z=== Omit Rst
User nn included (restored) zone
nn.
VKP Connected
Virtual keypad connected.
VKP Disconnected
Virtual keypad disconnected.
VKP Ex Keys Rstr
Excess keys tamper at virtual
keypad restored .
VKP Excess Keys
Excess keys (code attempts)
tamper at virtual keypad.
WAM== Battery Rstr
WAM low battery restored.
WAM== Low Battery
WAM has low battery.
WAM== PSU Fail
WAM has low power supply.
WAM== PSU Restore
WAM low power supply restored.
WAM== RF OK
WAM supervision OK.
WAM== RF Warning
WAM about to fail supervision.
WAM== Sndr Tamper
Not used.
WAM== Sndr Tmp Rst
Not used.
WAM== Sndr Trb Rst
Not used.
WAM== Sndr Trouble
Not used.
WAM== Superv Fail
WAM has failed supervision.
WAM== Superv Rstr
WAM supervision restored.
WAM== Tamper Rstr
WAM tamper restored.
WAM== Tamper
WAM tampered.
Websvr Ex Keys Rst
The system was retored after a
user keyed in the wrong password
on the web browser interface more
than four times in a row.
Websvr Excess Keys
Web server has caused a
tampered by a user trying to log
with the wrong password more
than four times.
WSN== Trouble Rstr
Trouble message from wired siren
restored.
WSN== Trouble
Trouble message from wired siren
input to control unit.
Z== Alarm Photos
Photos from an IP camera are
associated with a Zone Alarm
event.
Z== Closed
Zone quiescent.
Z== Follow Photos
Photos from an IP camera are
associated with a Zone Folllow
event.
Z== Open
Zone activated.
Z== RF OK
Radio zone supervision OK.
Z== RF Warning
Radio zone about to fail
supervision.
Z== Smoke Flt Rst
Smoke detector at zone has been
restored.
Z== Smoke Flt
Smoke detector at zone has fault.
Z== Smoke PSU Flt
Smoke detector at zone has power
supply fault.
Z== Smoke PSU Rst
Smoke detector at zone power
supply fault restored.
Z=== Shunted
Zone nn is shunted.
Z=== UnShunted
Zone nn has been un-shunted.
Email error messages
The following shows the SMTP server response codes in "Email error ---" log messages:
200 Non-standard success response
211 System status, or system help reply
214 Help message
220 <domain> service ready
221 <domain> service closing transmission channel
235 Successful authentication
250 Requested mail action OK, completed
251 User not local, will forward to <forward-path>
252 Cannot VRFY user, but will accept message and attempt delivery
253 Pending message for node started
334 Server challenge

Eaton i-on40H Specifications

General

Brand	Eaton
Model	i-on40H
Category	Security System
Language	English