Eaton i-on40H - IP Cam 1

Detectors/Devices Menu
Page 62
IP Cam 1...
Select the camera you wish to configure. The following options are available for each
camera:
Camera Triggers
Select the events that are to trigger images to be saved from the camera. For
example, if you select Yes for Fire Alarm, the control unit will save images from the
camera whenever a fire alarm occurs. You can select any one of the following events
(these mimic the output types; see page 63 onwards):
Fire Alarm
Hold Up Alarm
Burglar Alarm
Technical Alarm
24 Hour alarm
Perimeter
Duress Code
Tampers
Full Set
Part Set
Unset
Zone Follow
Zone Alarm
Zone Follow
This is displayed only if Camera Triggers – Zone Follow is set to Yes. You can
choose the zones for the Zone Follow trigger.
Zone Alarm
This is displayed only if Camera Triggers – Zone Alarm is set to Yes. You can choose
the zones for the Zone Alarm trigger.
Trigger Partitions
In a partitioned system, you can choose the partitions the camera and camera
triggers apply to.
IP address
Specify the IP address of the camera.
HTTP Port Internal
Specify the port used to communicate with the camera (default is 80).