Eaton i-on40H - User Menu Navigation and Zone Control

Addressing and Zone Numbering
Page 27
Figure
8.
Example of Detector Addressing and Zone Numbering (i-on40H)
On-board wired detectors
Wired detectors attached directly to the control unit (if applicable) use the following
address:
On-Board Wired
Detector Address
Zone Number
FSL* and 2-wire CC wiring
PAN<Z00 to PAN<Z09
000 to 009
4-wire CC wiring
PAN<Z01 to PAN<Z05
001 to 005
*If an ADP-10CC board is used, ten 4-wire CC zones can be used instead of ten FSL zones.
On-board radio detectors
Radio detectors that communicate directly with the control unit use the following
addresses:
On-Board Radio
Detector Address
Zone Number
i-on30R
PAN<Z00 to PAN<Z29
000 to 029
i-on40H
PAN<Z10 to PAN<Z39
010 to 039