Eaton i-on40H Engineering Guide

Log Messages
Page 141
Remote U-- Low Bat
Remote control belonging to user
has low battery.
Remsvc Comms Fail
A remote service call failed all
attempts.
Remsvc Complete
A remote service call succeeded.
RF Failure Restore
Radio restored.
RF Failure
Radio failed.
RF Jamming Restore
Radio jamming removed.
RF Jamming
Radio jamming detected.
RK == HUA
Hold Up Alarm raised at radio
keypad n.
RK== 4/6 Mismatch
Incorrect code length entered at 1-
way radio keypad.
RK== Ex Keys Rstr
The system was restored after a
user keyed in the wrong code
more than four times in a row at
radio keypad n.
RK== Excess Keys
Radio keypad n has been
tampered by excess key presses.
RK== Fire
Not used.
RK== Low Battery
Radio keypad n has low battery.
RK== RF OK
Radio keypad n supervision OK.
RK== RF Warning
Radio keypad n about to fail
supervision.
RK== Superv Fail
Radio keypad n failed supervision.
RK== Superv Rstr
Radio keypad n supervision
restored.
RK== Tamper Rstr
Tamper on radio keypad n
restored.
RK== Tamper
Tamper on radio keypad n.
RKBS Jam (==)
Radio jamming detected at radio
keypad base station n.
RKBS Jam Rs(==)
Radio jamming removed at radio
keypad base station n.
RKBS L V Rs(==)
Low voltage restored at radio
keypad base station n
RKBS Low V (==)
Low voltage at radio keypad base
station n
RKBS Tamp (==)
Tamper at radio keypad base
station n.
RKBS Tmp Rs(==)
Tamper restored at radio keypad
base station n.
RSN== Battery Rstr
Low battery Restored on Internal
Radio Sounder n.
RSN== Fault Rstr
Fault restored on External Radio
Siren n.
RSN== Fault
Fault on External Radio Siren n.
RSN== Jamming Rstr
Jamming Restored on External
Radio Siren n.
RSN== Jamming
Jamming on External Radio Siren
n.
RSN== Low Battery
Low battery on External Radio
Siren n.
RSN== RF OK
Radio signal restored for External
Radio Siren nn.
RSN== RF Warning
Radio signal lost for 20 min for
External Radio Siren nn.
RSN== Superv Fail
Radio signal fail for 2 hours for
External Radio Siren nn.
RSN== Superv Rstr
Radio signal restored for External
Radio Siren nn.
RSN== Tamper Rstr
Tamper Restore on External Radio
Siren n.
RSN== Tamper
Tamper on External Radio Siren n.
SD Card Error --
Error with SD card.
SD Card Missing
SD card missing.
SD Card Present
SD card present.
Sec Comms Path Flt
Secondary communications path
has a fault.
Sec Comms Path Rst
Secondary communications path
fault restored.
Set Fail Z==
Setting failed at zone.
Set Z=== Shunted
The system was set with zone nn
shunted
Shunt Group ## OFF
User nn de-activated shunt group
n.
Shunt Group ## ON
User nn activated shunt group n.
SMS Ex Keys Rstr
Excess keys tamper from SMS
message restored.
SMS Excess Keys
Excess keys (code attempts)
tamper from SMS message.
SMS Test Call
SMS test call made.
Soak Fail Z== Alm
Zone on soak test failed.
Soak Fail Z== Tmp
Zone on soak test tampered.
Software Changed
The installer has loaded a different
version of the control unit's
operating software.
Spch Tel = Ack All
All speech dialler destinations
acknowledged calls.
Spch Tel = No Ack
Speech dialler destination did not
acknowledge call.
Speech Tel = Ack
Speech dialler destination
acknowledged call.
Speech Test Call
Speech dialler made test call.
SRN== Battery Rstr
External radio siren n low battery
restored.
SRN== Fault
External radio siren n has a fault.
SRN== Fault Rstr
External radio siren n fault
restored.
SRN== Jamming
External radio siren n jammed.
SRN== Jamming Rstr
External radio siren n jamming
restored.
SRN== Low Battery
External radio siren n has low
battery.
SRN== RF OK
Radio siren n supervision OK.
SRN== RF Warning
Radio n siren about to fail
supervision.
SRN== Superv Fail
External radio siren n failed
supervision.
SRN== Superv Rstr
External radio siren n supervision
restored.
SRN== Tamper
External radio siren n tampered.
SRN== Tamper Rstr
External radio siren n tamper
restored.
Superv'n Fail Z==
Supervision failed for radio
detector at zone.
Superv'n Rstr Z==
Supervision restored for radio
detector at zone.
System 12V Fail
Control unit 12V supply failed.
System 12V Restore
Control unit 12V supply restored.
System Error
Control unit has fault in main
processor.
System Rearmed
User rearmed the system.
System Startup
The system restarted after a
power fail (mains and battery).
System Tamper Rstr
System tamper restored.
System Tamper
System tamper.
Tamper == Rstr
Tamper at expander\keypad
restored.
Tamper ==
Tamper at expander\keypad.
Tamper ==ER Rst
Tamper at external reader n
restored.
Tamper ==ER
Tamper at external reader n.
Tamper Z== Restore
Zone tamper restored.
Tamper Z==
Zone tamper.
Tech Z== Alarm
Technical alarm on zone.
Tech Z== Restore
Technical alarm on zone restored.
Test Call Fail
Test call failed.
Test Call OK
Test call succeeded.
Trace ==
Not used.
U-- Change U==
User nn changed their password.
U-- Config Change
User nn changed programming
configuration.
U-- Delete U==
User nn deleted another User nn
from system.
U-- Download Fail
Downloader session failed.
U--- Duress Restr
User nn keyed in a Duress code to
unset the system (part setting
system).
U--- Duress
User nn keyed in a Duress code to
set the system (part setting
system).

Eaton i-on40H Specifications

General

Brand	Eaton
Model	i-on40H
Category	Security System
Language	English