Eaton i-on40H - Page 43

Installer Menu Map
Page 33
Key A
Name: “Key A”
Setting: Partition 1 Full Set
OR Full Set in a Part Setting
System
Key B
Name: “Key B”
Setting: Partition 2 Full Set
OR Part Set B in a Part Setting
System
Key C
Name: “Key C”
Setting: Partition 3 Full Set
OR Part Set C in a Part Setting
System
Key D
Name: “Key D”
Setting: Partition 4 Full Set
OR Part Set D in a Part Setting
System
Zones
Disabled
Zone Type
Not used; use only 2-wire FSL.
Delete Keypad
Enable Keypad
Yes (all keypads enabled)
Replace Keypad
External
Sirens
Add/Del Siren
Edit Siren
Name
Partitions
Partition 01
Visible only in a partitioned system.
Internal
Sounders
Add/Del Sounder
Edit Sounder
Int. SNDR 01...
Name
"Int. SNDR nn"
Partitions
Partition 01
Visible only in a partitioned system.
Volume
4
WAMs
Add/Del WAM
Edit WAM
Cameras
IP Cam 1...
Camera Triggers
None
Zone Follow
Zone Alarm
Trigger Partitions
All Partitions
Visible only in a partitioned system.
IP Address
HTTP Port Internal
80
2 Outputs
Radio outputs
Add Outputs
Edit Outputs
EDIT RADIO O/P 1...
Name
"Output nnn"
Type
Not used
Pulsed
No
Partitions
All outputs allocated to all
Partitions
Visible only in a partitioned system.
Zones
None
Delay
0 seconds
Visible when Pulsed set to “Yes”.
On Time
1 second
Wired outputs
Panel
EDIT output
Name
Type
For dedicated siren and strobe
outputs, "Type" is "Siren" or
"Strobe" (as appropriate) and not
editable.
For odd-numbered panel outputs,
the default "Type" is "Siren". For
even-numbered panel outputs, the
default "Type" is "Strobe".
Polarity
Normal
Pulsed
No
Not available for dedicated siren and
strobe outputs.
Partitions
All outputs allocated to all
Partitions
Visible only in a partitioned system.
Zones
None
Delay
0 seconds
Visible when Pulsed set to “Yes”.