Eaton i-on40H - Page 48

Installer Menu Map
Page 38
Fast Fmt channels
Channel 1: Fire Alarm
Channel 2: Hold Up Alarm
Channel 3: Burglar Alarm
Channel 4: Open / Close
Channel 5: Zone Omit (System)
Channel 6: Tamper
Channel 7: Confirmed Alarm
Channel 8: General Fault
Visible only when Report Type is Fast
Format.
CID/SIA Events
Fire Alarm: Yes
Hold Up Alarm: Yes
Burglar Alarm: Yes
Technical Alarm: No
Masking: Yes
Tampers: Yes
Set/Unset: Yes
Part Set: Yes
Reset: Yes
Exit timeout: Yes
Omit: Yes
RF Supervision: Yes
RF Jamming: Yes
RF Battery/PSU: Yes
Panel Battery: Yes
Mains Fail: Yes
Faults: Yes
Installer Mode: Yes
User Code Changed: Yes
Time/Date Reset: No
Downloading: No
Visible only when Report Type is SIA
or CID.
Restorals
Enabled
Burg Comms Rearm
Enabled
Visible only if Confirmation Mode is
Basic and Report Type is Fast Format.
21CN FF Ack time
800ms
Visible only if a PSTN or GSM module
is fitted and Report Type is Fast
Format.
Send Tamp As Burg
Disabled
Visible only when Report Type is SIA
or CID.
Dynamic Test Call
Enabled
Visible only if Static Test Call is
disabled.
Static Test Call
Disabled
Visible only if Dynamic Test Call is
disabled.
Unset Comms
Enabled
Speech
Dialler
Call Mode
Disabled
Visible only if a suitable
communications module is fitted.
Messages
None
Triggers
None
Destinations
Call Acknowledge
Enabled
SMS
Outgoing
Call Mode
Disabled
Visible only if a suitable
communications module is fitted.
Messages
Blank
Triggers
None
Destinations
Incoming
Remote Control
Disabled
Forwarding
None
PSTN SMS
Protocol
ETSI Protocol 1
Visible only if a suitable
communications module is fitted.
Own Telephone No is visible only if
Protocol is UCP.
Service Centre Tel
1470,17094009
Own Telephone No.
Empty
Email
Call Mode
Disabled
Messages
Home Message
None
Message 1-4
None
Triggers
Message 1-4
None
Destinations
Message 1-4
None
Server
Server Name
None
Server Port Number
587
Account
None
Username
None
Password
None
SSL
Disabled