Eaton i-onEX Series - Page 40

3. Setting and Unsetting i-on40 & i-onEX Range
Page 34
Note: If the Installer has programmed the
system to complete setting by Lock Set
(see page 26) then you must go to the
designated lock and lock it in order to
complete the setting process.
The setting LED glows green for three
seconds.
Part Setting the System
Press and
hold:
The part setting LED flashes red three
times.
The system part sets. The control unit
sends a message to the fob.
The part setting LED glows green for three
seconds.
Unsetting the System
Press and
hold:
The un-setting LED flashes red three times.
The system unsets.
The unset LED glows green for three
seconds.
What Happens if the System Will Not Set
Press and
hold:
The setting LED flashes red three times.
The system tries to set. If there is a fault
(for example a door is open) then the
control unit sends a message to the fob to
say that it cannot set.
All four LEDs glow red for three seconds.