Eaton i-onEX Series - Page 97

i-on40 & i-onEX Range 4. Administration
Page 91
c) Press  to select it.
The display shows the first
button on the remote control.
Note: Only the “*” button (Part set) is
available on a FOB-2W-4B.


d) Press  or  to show the button
you wish to re-program.


e) Press  to select the button.
The bottom line shows:
Note: If your system is a part setting
system (there are no partitions)
then you cannot reprogram the
unset key on a remote control.
If your system is a partitioned
system then the unset button
can only be programmed to
unset all partitions allocated to
the user, or unset individual
partitions allocated to the user.


10. Choose either Set or Unset, as
follows:
a) Press  .
In the example on the right, the
button is currently programmed to
unset.


b) Press  to change the bottom
line between Set or Unset:


c) Press  .
The bottom line of the display
now shows the first item in a list
of setting or unsetting options that

