Eaton INV-STS-050 - Frame Assembly; Task 1

To Next Page

To Previous Page

Matrix Telecom Inverter System

IPN 997-00012-68D February 2010

100A STS/controller/interface Chassis

Includes: 23" rack mount brackets (2), interconnection bus bars (3), busbar screws (8),

mounting screws (4), CAN cable for controller (1), DC power cable for controller (1),

communications cable (1), 4-pin jumper (for CN1 if BMS is not used)

50A MBS/PD Shelf

Includes: 23" rack mount brackets (2), interconnection bus bars (5), busbar screws (5),

mounting screws (4)

100A MBS Shelf

Includes: 23" rack mount brackets (2), interconnection bus bars (5), busbar screws (12),

mounting screws (4), jumper (1), cable grommets (3)

Frame Assembly

Task 1 - Inverter Chassis Assembly

Step 1 - Change mounting brackets if required

The inverter chassis is pre-installed with 19-inch rack brackets.

For 23-inch rack mounting, replace the mounting brackets.

Eaton INV-STS-050 - Frame Assembly; Task 1 - Inverter Chassis Assembly