Eaton LMR PLUS O & M Manual

O & M Manual IM05805020K EATON LMR Plus
Effective September 2013 Electric Fire Pump Controllers
EATON CORPORATION www.chfire.com Page 30
PUMP STOPPED The pump has stopped after a stop sequence has been initiated
REMOTE START The pump has stated via a remote start signal
ROOM TEMPERATURE OK The low room temperature alarm has cleared
RPT TIMED OUT The running period timer has finished its timing cycle
SEQ START DELAY A start sequence has been started, however, it is delayed due to the programmed
sequential start timer
SST STOPPED The sequential start timer has stopped timing
SYSTEM STARTUP Power has been reapplied to the system and a successful system boot has been
completed
TRANSDUCER FAILURE The controller has detected that the transducer has failed
TRANSDUCER OK The controller has detected that the transducer is in good working condition
UV PHASE AB The voltage measured between phases A and B has dropped below the programmed
undervoltage set point
UV PHASE BC The voltage measured between phases B and C has dropped below the programmed
undervoltage set point
UV PHASE CA The voltage measured between phases C and A has dropped below the programmed
undervoltage set point
WEEKLY TEST DONE The weekly test has been completed
WEEKLY TEST START The pump has started on a weekly test
WEEKLY TEST STOP The pump has stopped after a weekly test cycle
Message Description

Eaton LMR PLUS Specifications

General

Brand	Eaton
Model	LMR PLUS
Category	Controller
Language	English