Eaton Moeller ZEV Series - Connections

Mounting the devices
25
11/01 AWB2300-1433GB
ZEV-XSW-820 fastened on a F
FF
F 50 mm
2
power cable
with cable ties
Figure 19: Installation of the cable ties and wiring of the sensor
cables
X
Strap the current sensor to the power cable using the
cable tie.
X
Install the sensor cable so that each one loops only one
power cable.
Connections
Table 7: Conductor cross-sections of the auxiliary cables
mm
2
mm
2
AWG mm N/m
1 x (0.5 to 2.5) 1 x (0.5 to 2.5) 18 to 12 0.8 x 5.5 Z1 0.8
2 x (0.5 to 1.0) 2 x (0.5 to 1.0) 18 to 12 0.8 x 5.5 Z1 0.8
2 x (1.0 to 1.5) 2 x (1.0 to 1.5) 18 to 12 0.8 x 5.5 Z1 0,8