Need help?Do you have a question about the Eaton MP3010 and is the answer not in the manual?
General| Weight | 0.1 LB |
|---|---|
| Voltage | 600 V |
| Poles | 3 |
| Rated Operational Voltage | 600 V |
| Electrical Durability | 100, 000 operations |
| Contact Material | Silver Alloy |
| Number of Poles | 3 |
| Operating Temperature Range | -40°C to 70°C |
How the MP-3000 is designed for motor utilization and protection against faults.
How to change MP-3000 settings and guidance on understanding settings.
Setting the maximum stator continuous RMS current in amperes.
Sets the instantaneous over current trip limit as a percentage of FLA.
Sets current level below which motor loss of load is detected.
Settings to configure alarm functions, each can be disabled.
Settings controlling motor starting and jogging functions.
Configures which events activate the alarm relay.
Setting the motor current when stalled, as a percentage of FLA.
Sets the motor bearing temperature limit for tripping.
Sets the load bearing temperature limit for tripping.
Sets the motor jam current trip limit as a percentage of FLA.
Sets percent of phase unbalance above which the relay trips.
Configures events that activate AUX1 output relay and load shedding.
Configures events that activate AUX2 output relay.
Configures overall operation of the MP-3000.
Tests the trip relay by energizing or de-energizing it.
Resets or clears accumulated history mode statistics.
Sets the motor stator winding temperature limit for tripping.
Specifies the numerator of the main phase current transformer turns ratio.
Settings that configure the trip functions of the MP-3000.
Blocks or enables trip output contacts for maintenance.
Sets the ground fault trip current pickup level.
Test settings for MP-3000 inputs and outputs.
Sets thermal accumulator level at which the relay alarms.
Sets current level defining transition from START to RUN state.
Selects action for internal diagnostic failures.
How thermal models and rotor temperature protect the motor.
How the MP-3000 protects motors, starters, and loads.
Feature for blocking trip output contacts during maintenance.
Using MP-3000 info to help localize monitored equipment problems.
How trip conditions operate the trip relay and other contacts.
Feature for blocking trip output contacts during maintenance.
To Next Page