Power Xpert Insight Gateway
Quick Start Guide
1
Preface
This Quick Start Guide covers mounting, installation, wiring, and
conguration for the Power Expert Gateway 900E (PXG 900E). It
also covers how to place it on a local area network and how to
add devices through either of the Modbus ports or the INCOM
port. Read the entire document and understand all safety pre-
cautions before proceeding with installation, wiring, and opera-
tion.
For technical support, please contact the Eaton Customer Suc-
cess Team. You can reach them by:
Phone: 1-800-809-2772 (or 414-449-7100) Ext. 4,1
Email: pqsupport@eaton.com
Safety Information
All safety codes, safety standards and/or regulations must be
strictly observed in the installation, operation, and maintenance
of this device.
WARNING
Indicates a hazardous situation, which, if not avoided,
could result in death or serious injury.
CAUTION
Indicates a hazardous situation, which, if not avoided,
could result in minor or moderate injury.
NOTICE
Indicates a situation which can cause damage to the unit,
personal property and/or the environment or cause the
equipment to operate improperly.
WARNING
The safety message that follows has WARNING level haz-
ards.
SHOCK HAZARDS!
Follow all Warnings and Cautions. Completely read and
understand the information in this document before at-
tempting to install or operate the equipment. Only quali-
ed personnel are to service any Power Xpert device.
INSTALLATION AND TROUBLESHOOTING PROCEDURES
MAY REQUIRE PROXIMITY TO EXPOSED ENERGIZED (LIVE)
ELECTRICAL WIRING AND/OR PARTS WHERE THE HAZARD
OF FATAL ELECTRIC SHOCK IS PRESENT.
Properly ground the PXG900 during installation.
To Next Page
Loading...
Need help?
General
