21
©2015 Eaton Corporation
All rights reserved
REC Series Enclosure Installation Guide _issue 4
Installation Guide
Step – 8
Fit the doors by orientating them at right-angles to the frame and lifting them onto the
hinge pins.
Note the door positions and panel gaps can be adjusted by loosening the hinge fixing
screws and altering their relative positions. The gap between the door and frame should
be approximately 3 to 4mm all around.
The hinge adjusting screws are accessed from the rear of the frame and doors (inside the
aisle).
DOOR HINGE ADJUSTMENT
SCREWS.
To Next Page
Loading...
