Eaton TRIPP LITE Series - Page 14

8 Eaton Tripp Lite Series Cloud Connected UPS Systems User Guide 934859—Rev B
To secure the UPS, follow the below steps:
1. Measure and mark the hole locations on the wall. Use a screwdriver to install the screws in the wall,
leaving the screws extended 0.28 inches.
Figure 10. BC350RNC(AG-075F) / BC600RNC(AG-0760) Wall Mounting Hole Dimensions
100.0
[3.94]
100.0
[3.94]
40.64
[1.60]
27.48
[1.08]
17.2
[.68]
52.07
[2.05]
41.1
[1.66]
39.87
[1.57]
40.0
[1.57]
9.39
[.37]
102.61
[4.04]
100.0
[3.94]
Figure 11. BC850RNC(AG-0761) Wall Mounting Hole Dimensions
9.39
[.37]
46.48
[1.82]
26.3
[1.03]
100
[3.94]
100
[3.94]
53.2
[2.09]
40.0
[1.57]
40.0
[1.57]
100
[3.94]
46.48
[1.82]
121
[4.76]
17.02
[.68]
2. Center the UPS keyhole openings over the screw heads and push towards the wall and then down lightly
to lock it onto the screws.
3. To detach the UPS from the wall, lightly push up on the bottom of the UPS to release it from the wall.
4. Carefully lift the UPS off the wall.
Wall Mount Installation