10 Eaton Tripp Lite Series Cloud Connected UPS Systems User Guide 934859—Rev B
• To enable the alarm tone in Battery Mode, press and hold the power button for five seconds. The green
LED will flash and the UPS alarm tone will sound, indicating that the alarm has been enabled.
NOTE To verify the alarm status, test the UPS on battery power.
33..55 TTuurrnniinngg tthhee UUPPSS OOffff
To turn off the UPS, press and hold the ON/OFF button on the front panel for two seconds, the UPS will beep
indicating it is in Standby Mode. Unplug the UPS from the power source. If you do not unplug the UPS, it
remains in Standby Mode.
33..66 LLEEDD IInnddiiccaattoorrss
The Tripp Lite Series UPS system rear panel indicates the UPS status via the UPS LED indicators. Table 2
shows the LED status and operational mode of the UPS.
Table 2. LED Status
LED Status Alarm UPS Status
Green (On) Off Operating in normal line mode and the
battery is fully charged
Green (Flashing every ten seconds) Off Operating in battery mode
Green (Flashing) Red (On) Sounding every second Low battery
Green (Off) Off UPS is off
Red (On) Continuously sounding UPS fault (See Table 6)
Green (Flashing On for five seconds/Off
for five seconds)
Off Operating in normal line mode and
charging the battery
Turning the UPS Off
To Next Page
Loading...
