Eaton XN300 - Dismantling XN-332-5 ETH-UMS

4
Installation
INSTRUCTION MANUAL MN050011EN August 2022 www.eaton.com
Step 4. Tilt XN-332-5ETH-UMS forward and place it against
the DIN rail’s bottom edge in an inclined position.
Step 5. Push the XN-332-5ETH-UMS over the DIN rail’s
top edge.
Figure 5. Place the XN-332-5ETH-UMS against the
bottom edge of the DIN rail
Step 6. Push the locking elements on the back of the
XN-332-5ETH-UMS downward in order to secure
the modules. You can use a screwdriver to do this.
Figure 6. Locking the XN-332-5ETH-UMS into place on
the DIN rail
Step 7. Check to make sure that the XN-332-5ETH-UMS
is solidly mounted.
Dismantling XN-332-5ETH-UMS
To remove the XN-332-5ETH-UMS, follow the steps below:
Step 1. Slide the locking elements on the back of the
XN-332-5ETH-UMS upward. You can use a
screwdriver to do this.
Figure 7. Disengaging the XN-332-5ETH-UMS
Step 2. Tilt the XN-332-5ETH-UMS forward, and then
pull the block from its bottom edge, away from
the DIN rail.
Figure 8. Place the XN-332-5ETH-UMS against the
bottom edge of the DIN rail
5
4
6
RN
DC
LA
X1
FD
LA
X2
FD
LA
X3
FD
LA
X4
FD
LA
X5
FD
1
2