Why does the power LED not come on for my EBARA A10S?
If the Power LED does not come on for your EBARA Water Pump, it could be due to no power supply to the pump (check the power supply), the connector not being connected (connect the power connector), or the ELB not being ON (switch ELB ON).
How to fix abnormal noise and excessive vibration in EBARA Water Pump?
If you are experiencing Abnormal noise or Excessive vibration with your EBARA Water Pump, it could be due to several reasons. The adjuster foot may not be lowered, so properly set all adjuster feet. The cover might be in contact with other items, so remove objects from the cover. The cover screws could be loose, so tighten the mounting screws. Also, a pump part could be damaged, so replace or overhaul the pump if needed.
What to do if I see ALARM: WATER FLOW LOW on my EBARA A10S Water Pump?
If you see the ALARM: WATER FLOW LOW ##.# on your EBARA Water Pump, it could be due to several reasons: the coupler might be disconnected (connect it), the pressure may not be sufficient (apply sufficient pressure), the source valve could be closed (open the valve), the water piping might be clogged (clean or replace it), there could be leaks in the water piping (check the fittings), the instruments might be in failure (replace instruments), or the inlet/outlet might be reversed (connect correctly).
Defines DANGER, WARNING, and CAUTION terms.
Instructions for connecting vacuum, exhaust, N2, and cooling water lines.
Details on local and remote operation modes and pump status.
Lists common issues, checks, and corrective actions.
Explains alarm displays, symptoms, check items, and corrections.
Lists trip conditions, symptoms, check items, and corrective actions.
General| Brand | EBARA |
|---|---|
| Model | A10S |
| Category | Water Pump |
| Language | English |
To Next Page
