EBARA DML - User Manual

Other manuals for EBARA DML

Operating And Maintenance Instructions144 pages

Questions and Answers

J
Jason MooreAug 2, 2025
How to troubleshoot if my EBARA DML Water Pump does not start?
- A
  austinsmithAug 2, 2025
  If your EBARA Water Pump isn't starting, consider the following: * Remove any obstacles that may be preventing it from starting. * Inspect the connection section and the magnet switch. * Ensure the wiring is in the correct state. * Replace any inadequate fuses with adequate ones. * Replace inadequate magnets with adequate ones. * Repair or replace the level switch, motor, bearing, or mechanical seal if necessary. * Remove any foreign matter that may be obstructing the pump. * Request the electric power company for action.
I
ithompsonAug 7, 2025
What causes over current in my EBARA DML and how to fix it?
- K
  Kim CobbAug 7, 2025
  If your EBARA Water Pump is experiencing an over current, here's what to investigate: * For large fluctuations of power source voltage, request the electric power company for action. * Inspect the connection section and the magnet switch. * Check the nameplate. * If operating the 50Hz pump at 60H, establish the correct rotational direction. * Narrow the opening of the gate valve, or if there is no gate valve, replace the pump with one having a lower head. * If the pump caches foreign matter, disassemble the pump to remove it. * If the motor bearing is broken, repair or replace the bearing.
J
James ChavezAug 13, 2025
Why is my EBARA Water Pump vibrating and generating large noise?
- C
  Christian PattersonAug 13, 2025
  If your EBARA Water Pump is vibrating and generating a lot of noise, consider these potential issues: * If the pump is running in reverse, establish the correct rotational direction. * Disassemble the pump to remove any foreign matter. * If the piping is in resonance mode, modify the piping.
F
Frederick BlackAug 17, 2025
What to do if EBARA DML can be operated, but it stops after a while?
- D
  Daniel WardAug 17, 2025
  If your EBARA Water Pump operates but stops after a while, it could be due to: * Prolonged dry operation causing the Auto-cut to function. In this case, raise the water level. * High liquid temperature triggering the Auto-cut. Try lowering the water level.
K
Kelsey ButlerAug 22, 2025
Why is the thermal protector actuated in my EBARA DML?
- M
  Michael GordonAug 22, 2025
  If the thermal protector is actuated in your EBARA Water Pump, it might be due to: * High liquid temperature. In this case, lower the liquid temperature. * Long dry operation. Raise the stopping water level.
T
Tina PerezOct 27, 2025
What to do if my EBARA DML does not pump or has insufficient pumping rate?
- J
  judy73Oct 27, 2025
  If your EBARA Water Pump isn't pumping or the pumping rate is insufficient, here's what you can check: * Ensure the pump isn't running in reverse. You may need to establish the correct rotational direction. * If the operating water level is low, it might be causing air suction. Try raising the water level or lowering the pump position. * Inspect the discharge pipe for any leaks and repair if necessary. * Remove any foreign matter that may be clogging the discharge pipe or adhered to the suction opening. * If foreign matter clogs the pump, disassemble the pump to remove it. * If you find a worn impeller, replace it. * Request the electric power company for action if there is a large voltage drop. * Check the nameplate if you are operating the 60Hz pump at 50Hz. * Review t...