EBS CPX200NB - Arming the System; Arming Modes Explained; System Arming Procedure; Stay Mode Arming

CPX200NB ALARM CONTROL UNIT – USER MANUAL 10 / 30
EN
4. ARMING THE SYSTEM
4.1. ARMING MODES
Each partition can be armed in one of the following modes:
 Stay (perimeter) – partition is armed, but only perimeter and perimeter
exit zones violation will cause an alarm,
 Away (full) – partition is armed and violation of any zone will cause an
alarm.
User can choose the arming mode or let the system do it for himself.
4.2. ARMING THE SYSTEM
Stay mode is in fact a part of the Away mode. Every time a correct code is
given, the system will immediately arm in the stay mode (provided it has
perimeter zones). Afterwards, the system can automatically arm in the away
mode, if proper conditions were met.
4.2.1. Stay mode
Arming the partition in stay mode is possibile only if it has perimeter zones
assigned to it.
Partition will arm in the stay mode in following cases:
1. Input the user code, press and hold the button for 3 seconds
1
.
2. Input the user cold and press the button. If the perimeter exit zones
is violated during the exit time countdown, partition will arm in away
mode. If perimeter zone is not violated during the exit time countdown,
partition will remain armed in the stay mode.
1
Works only with KP16 keypad
Note: If incorrect code is entered the keypad will emit long
constant sound. Repeat the arming process by entering the
correct code.
Note: If the partition is not plugged any zones and/or outputs,
the partition is not armed.