The function displays the history of alarms that occurred in the system. When the
function is activated, ALARM and PROG LEDs are flashing slowly and all alarms that
occurred since last arming are displayed. LEDs 1 – 7 display the information from
which zones the alarm was activated. To clear the alarms memory, press . To
exit without clearing the alarms memory, press .
Alarm source types:
Diodes 1 to 7 – Sabotage of lines 1 to 7
If no diodes are on and the ALARM led is blinking, then there alarms that were
triggered by the source other than input lines.
Other alarms
history can be accessed
by selecting following code from the main menu: .
After pressing the button corresponding to active LED, the detailed information about
the alarm source within selected type is displayed.
Pressing will result in return to the main menu.
Other alarm source types:
2 – Keypads tamper
3 – Emergency button used
Other alarm source types -> Keypads tamper:
1 – Keypad tamper 1
2 – Keypad tamper 2
3 – Keypad tamper 3
Other alarm source types -> Emergency button used:
1 – Fire alarm activated
2 – Help alarm activated
To Next Page
Loading...
