EasyManua.ls Logo

Ebyte E108-GN Series - Set NMEA Output; GPD Document Delete; Set NMEA Serial Port Parameter; PPS Configuration

Ebyte E108-GN Series
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chengdu Ebyte Electronic Technology Co.,Ltd. E108-GN User Manual
Copyright ©2012–2021
,
Chengdu Ebyte Electronic Technology Co.,Ltd.
2
22
7.2.10 Set NMEA output
Command: 147
Set NMEA output baud rate
;
Arguments:
Arg1:
9600,19200,38400,57600,115200……921600,
Example:
$PGKC147,115200*06<CR><LF>
7.2.11 GPD document delete
Command: 047
Delete GPD doc in flash
Arguments:None
Example
:
$PGKC047*2C<CR><LF>
7.2.12 Set NMEA serial port parameter
Command
:
149
Set NMEA serial port parameter
Arguments
:
Arg1:
“0”,NMEA data
“1”,Binary data
Arg2:9600,19200,38400,57600,115200……921600,
Example
:
$PGKC149
,
0
,
38400*2C<CR><LF>
$PGKC149
,
1
,
115200*15<CR><LF>
Remarks: This command is usually used in AGPS to load GPD files into Flash; the baud rate modification requires firmware version 3.0
or above to support configuration;
7.2.13 PPS configuration
Command: 161
PPS configuration
Arguments:
Arg1:
“0”,turn off PPS output
“1”
,
first time fix
“2”
,
3D fix
“3”
,
2D/3D fix
“4”,always on
Arg2:
PPS pulse width
(
ms
)
Arg3
:
PPS pulse period(ms)
Example:
$PGKC161
,
2
,
500
,
2000*0<CR><LF>
Note: The maximum pulse width of PPS is 998ms, the minimum is 1ms, and the minimum range of pulse period is 1000ms.
7.2.14 Query message interval
Command
:
201
Query interval for NMEA messagesArguments: None

Table of Contents