Ebyte E22-230T33S - 6.3 WOR Mode (Mode 1); 6.4 Configuration mode (Mode 2); 6.5 Deep sleep mode (mode 3); 7 Register read and write control

Chengdu Ebyte Electronic Technology Co.,Ltd. E22-230TXXS User Manual
Copyright ©2012–2024，Chengdu Ebyte Electronic Technology Co.,Ltd.
14
6.3 WOR Mode (Mode 1)
Type
When M0 = 1 and M1 = 0, the module works in mode 1
TX
When defined as the transmitting side, the wake-up code is automatically added for a certain time before launch
RX
Data can be received normally, and the receiving function is equivalent to mode 0
6.4 Configuration mode (Mode 2)
Type
When M0 = 0 and M1 = 1, the module works in mode 2
TX
Wireless launch closed
RX
Wireless receive closed
Configure
The user can access the register to configure the module operating state
6.5 Deep sleep mode (mode 3)
Type
When M0 = 1 and M1 = 1, the module works in mode 3
TX
Unable to transmit the wireless data.
RX
Unable to receive the wireless data.
Note
When entering from the hibernation mode to the other mode, the module will reconfigure the parameters, and the
AUX remains low during the configuration process;
After the output high level, so it is recommended that the user detect the AUX rising edge.
7 Register read and write control
7.1 Directive format
Under the configuration mode (mode 2: M1=1, M0=0), the supported instruction list is as follows (when setting,
only 9600,8N1 format is supported):
No
Format
Define