Ebyte E22-230T33S - 9 Configuration software description

Chengdu Ebyte Electronic Technology Co.,Ltd. E22-230TXXS User Manual
Copyright ©2012–2024，Chengdu Ebyte Electronic Technology Co.,Ltd.
20
9 Configuration software description
 The following figure shows the display interface of E22-230T22S. Users can switch to command mode through M0
and M1, and quickly configure and read parameters in the upper computer.
 In the configuration computer, the module address, frequency channel, network ID and key are all decimal display
mode; taking the values of each parameter:
Network address: 0~65535
Frequency channel: 0~64
network ID:0~255
Key: 0~65535
 When using the upper computer configuration relay mode, users need to pay special attention to, because in the
upper computer, each parameter is decimal display mode, so the module address and network ID need to be filled in
through the conversion input system;
If the network ID input by the transmitter A is 02 and the network ID input by the receiver B is 10, then the relay R