13
OPERATION
INTRODUCTION
This operation procedure guides you through a typical process on how to set a M.O.L.E.
thermal proler up for performing a data run. For additional detail, consult the Help
System in the software.
The M.O.L.E. thermal proler depends on the MAP (Machine-Assembly-Process) software
to control how it collects and interprets data. Several kinds of data runs may need to
be performed to achieve desired information, or the same data run may be performed
repeatedly over time to monitor one process. Either way, each data run must be set up
at least once.
The MAP software includes wizards that help you get started quickly, even if you are a
beginner or infrequent user.
To Next Page
Loading...
