32
|
ERROR CODES & TROUBLESHOOTING
ERROR CODE PROBLEMS SOLUTIONS
E05
Over-current
Protection
1. Check if any part on motor is stuck. Unplug power cable and adjust motor. Plug back in the power cable
and re-start to run the treadmill.
2. Check if motor has burned smell. If so, the motor will need changed.
3. Check if lower control board has burned smell. If so, the lower control board will need changed.
4. Check if power outlet has low voltage supply. If so, the power outlet will need changed.
E06
Self-checking error
on controller
1. Check if wires of motor are well connected and in good condition.
2. Check if IGBT on lower control board has burned smell. If so, change a lower control board.
3. Check if PCB is in good condition.
E07 Parameter lost Replace a lower control board. Please contact customer service at 833-937-2453.
E08
EEPROM damage (on
lower control board)
Replace a lower control board. Please contact customer service at 833-937-2453.
E09
Voltage issue or IPM
over-heated
Replace a lower control board. Please contact customer service at 833-937-2453.
EEP
EEPROM damage (on
upper control board)
Replace a console (upper control board is assembled together with console).
NO CODE
SHOWN
Motor damage or
motor circuit damage
1. Check if wires connected to motor are well connected.
2. Check if fuse on lower control board is damaged. If so, change a new lower control board.
3. Check if IGBT on lower control board is working by using the multi-meter. If so, change a lower control board.
Please contact customer service at 833-937-2453.
ERROR CODES & TROUBLESHOOTING
To Next Page
Loading...
