ERROR CODES & TROUBLESHOOTING
|
31
ERROR CODE PROBLEMS SOLUTIONS
E01
Connection fails
between “PCB” and
“Lower Control Board”
1. Check every wire is connected well between PCB and lower control board.
2. Check if any of the wire is damaged.
3. Check if PCB or lower control board is in good condition. If any chip is damaged, change PCB or lower control board.
E02
Over-loading
Protection
1. Check if power outlet has low voltage supply. If so, change a power outlet.
2. Check if lower control board has bad smell. If so, change a lower control board.
3. Check if wires connected to motor are well connected.
E03
No signal from
speed sensor
1. Check if wire of speed sensor is well connected.
2. Check if wire or speed sensor is damaged. If so, replace wire and speed sensor.
E04 Incline motor error
Perform incline calibration
1. Remove Safety Key
2. Press and hold both “Start” and “Stop” buttons for over 3 seconds.
3. After the incline calibration is completed, test the treadmill again by powering on and press “Start” button.
CONNECT TO ECHELON FIT
®
APP
To connect the Echelon Fit
®
app and begin a live session, search and download “Echelon Fit” from the Apple App Store or Google Play.
Follow the prompts in the app for Bluetooth connection and registration.
ERROR CODES AND TROUBLESHOOTING
ERROR CODES & TROUBLESHOOTING
To Next Page
Loading...
