BELT ADJUSTMENT
|
23
Belt Adjustment:
If the belt has drifted right, unplug the safety lock and power switch and
turn the right adjusting bolt 1/4 turn clockwise. Insert the power switch
and safety lock, run the treadmill, and observe the running belt’s position.
Repeat until the running belt is centered on the running deck.
If the belt has drifted left, unplug the safety lock and power switch
and turn the left adjusting bolt 1/4 turn clockwise. Insert the power
switch and safety lock, run the treadmill, and observe the running belt’s
position. Repeat until the running belt is centered on the running deck.
NOTE: The belt comes pre-lubricated. No lubrication required.
12
STEP
BELT ADJUSTMENT
POWER OFF AND UNPLUG TREADMILL BEFORE ADJUSTING THE BELT.
To Next Page
Loading...
