Echo CS-2511T

19
CS-2511T
RUNNING
• When engine starts, keep idling for a few
minutes.
• Set the brake lever in the unlocked position
before starting to cut.
• Pull throttle trigger gradually and increase
revolution of the engine.
• The chain starts running when the engine
reaches 4300 r/min approximately.
• Conrm proper acceleration and lubrication of
chain and bar.
• Do not run the engine at high speed
unnecessarily.
• Be sure that saw chain stops moving when
throttle trigger is released.
STOPPING
• Release throttle trigger and place ignition switch
in “STOP” position.
NOTICE
If engine does not stop, turn choke control knob
counterclockwise to stop engine.
Return the unit to your authorized ECHO dealer
to check and repair ignition switch before starting
the engine again.
CHECKING CHAIN TENSION
• Chain tension should be checked frequently
during work and corrected as necessary.
• Tension the chain as tight as possible, but so it
can still be pulled easily along the bar by hand.
CAUTION
Do not operate with a loose chain.
CHAIN LUBRICATION TEST
Hold the chain just above a dry surface and open
the throttle to half speed for 30 seconds.
A thin line of “thrown” oil should be seen on the
dry surface.
Throttle trigger
Unlock chain brake