OPERATION CS-2511T
34 X7503332503
© 11/19 ECHO Incorporated
Stopping
1. Release throttle trigger and allow
engine to idle.
2. Move ignition switch
REARWARD to “STOP” position.
Note: If engine does not stop, rotate
choke control knob
counterclockwise, to full
choke, to stop engine. Return
the unit to your authorized
dealer to check and repair
ignition switch before starting the engine again
.
Checking Chain Tension
Do not operate with a loose chain. Serious injury can occur.
Chain tension should be checked
frequently during work and corrected
as necessary.
Chain Lubrication Test
Hold the chain just above a dry
surface and open the throttle to half
speed for 30 seconds.
A thin line of “thrown” oil should be
seen on the dry surface.
Shown with optional
Kick Guard
TM
Shown with optional
Kick Guard
TM
To Next Page
Loading...
