Echo CS-271T - Page 42

CHAIN BRAKE SYSTEM
CS-271T
40
6-1Disassemblingchainbrake
WARNING DANGER
Weareyeprotectionandsafetygloveswhen
disassemblingorassemblingchainbraketo
protecteyeandhandfrominjury.
1. Remove sprocket guard from the unit.
2. Move brake lever (A) to chain brake engaging
position.
3. Remove bolt (a) and remove brake lever (A)
from sprocket guard.
NOTE: Make sure that brake connector (B) is in
engaging position before removing brake cover (C),
otherwise compression spring may jump out.
Released position Engaging position
4. Loosen two screws (D) securing brake cover (C)
and remove brake cover.
5. Inspect all the brake parts for damage. Replace
them as required.
A
a
B
D
C