CHAIN BRAKE SYSTEM
CS-271T
41
6-2Assemblingbrakeparts
1. Install pin (A) through brake band hole (b).
2. Install brake band (B) with pin (A) in sprocket
guard as shown in the left picture. Set brake con-
nector (C), spacer (D) and spacer (E), placing the
notch (d) of spacer (D) as shown. Make sure the
pin (c1) of brake connector (C) is engaging with
the groove (F) of sprocket guard.
3. Slide in compression spring (G) to the end (c2)
of brake connector as sown.
4. Push compression spring (G) with driver etc.
and install compression spring in sprocket guard
as shown in the below picture.
5. Apply molybdenum grease on entire compres-
sion spring and other friction parts.
6. Reinstall brake cover.
A
d
E
C
D
B
b
G
c2
F
A
C
c1
To Next Page
Loading...
