EasyManuals Logo

Echo CS-330T User Manual

Echo CS-330T
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
16
STARTING COLD ENGINE
WARNING
Make sure bar and chain are not touching anything when
starting the saw.
1. Move chain brake lever (E) fully forward to lock chain brake
before starting.
2. Fill the fuel tank with fuel. Do not over ll.
3. Fill the chain oil tank with lubricant. Do not over ll.
4. Move ignition/choke lever (A) forward to “close choke” ( )
position.
5. Lay unit on a at, clear area and keep bar and chain clear of
all obstacles. Hold top handle with one hand, and depress
throttle trigger lockout (C), but do not depress throttle trigger
(D).
6. Pull starter handle (F) several times until engine starts, or
rst starting sound is heard. (7 pulls maximum)
CAUTION
After starting the engine, wait 5 seconds, then squeeze and
release throttle trigger (D) to release fast idle throttle latch,
otherwise severe brake damage may occur.
Never use fast idle throttle latch for cutting.
Use the fast idle throttle latch only in starting.
WARNING
After choke lever is moved to run position, throttle remains
slightly open (fast idle latch condition).
The chain will attempt to move when engine is started with
fast idle throttle latch engaged.
Do not start engine before chain brake is locked.
NOTE
Do not pull starter rope out to the maximum possible position.
Do not allow recoil handle to snap back against the casing.
7. Move ignition/choke lever back to “run” ( I ) position (B). (Do
not move to “Stop” position [G].) If necessary, start the en-
gine.
NOTE
If engine does not start after 3 pulls with choke in “run” ( I )
position, repeat cold start instructions 4-7.
8. Allow unit to warm up at idle for several minutes.
B
C
A
C
D
E
C
F
G
E
C
IMPORTANT
This saw features a combination ignition/choke switch that automatically sets the throttle speed to fast idle for
quick starting. Do not squeeze trigger during cold starts until after unit has started, or fast idle and choke set-
tings will be released, and engine may not start.
NOTICE
Do not increase engine speed while chain
brake is locked. Severe brake damage will
result.

Other manuals for Echo CS-330T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo CS-330T and is the answer not in the manual?

Echo CS-330T Specifications

General IconGeneral
BrandEcho
ModelCS-330T
CategoryChainsaw
LanguageEnglish

Related product manuals