Echo CS-330T User Manual

21
The following combinations may be used on CS-330T.
cHAIn AnD gUIDe BAR comBInAtIons
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
WARNING
Use of replacement saw chain and/or guide bar other than that specied, or operation without the “tip guard” in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets CSA Z62.1, Z62.3 Standards when tested on
the representative sample of chain saws below 3.8 C.I.D., and the Echo guide bar specied.
GUIDE BAR
(Low-kickback)
Replacement guide bars.
The following guide bars may be considered to
have equivalent kickback energy.
• Sprocket nose guide bars of the same length and
nose radius, same pitch and having the same
number of teeth.
• Hard nose guide bars of the same length and
nose radius as a sprocket nose bar.
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the
Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.
SAW CHAIN
(Low-kickback)
CAUTION
Do not use replacement saw chain unless
it has been designated as meeting the
CSA Z62.1, Z62.3 kickback performance
requirements.
NOTE
LOW KICKBACK SAW CHAIN meets the
kickback performance requirements of CSA
Z62.1, Z62.3(safety requirements for gasoline-
powered chain saws).
MODEL
BAR
LENGTH
LOW KICKBACK
GUARD BAR
LOW KICKBACK SAW CHAIN
KICK
GUARD
BAR P/N CHAIN PART NO.
LINKS
TYPE
PITCH
GAUGE
ECHO P/N
(OEM P/N)
CS-330T
12”
14”
16”
12A0ED3745
14A0ED3752
16A0ED3757
91PX-45 91VG-45
91PX-52 91VG-52
91PX-57 91VG-57
45
52
57
91PX
91VG
3/8” 0.050
2894901
28949

Echo CS-330T Specifications

General

Brand	Echo
Model	CS-330T
Category	Chainsaw
Language	English