32
STORAGE AFTER USE
• Inspect and adjust every part of the chain saw.
- Completely clean every part and repair if
necessary.
- Apply thin coating of oil on metal parts to prevent
rust.
• Remove chain and guide bar.
• Drain fuel tank completely. Press purge bulb 6 - 7
times to remove remaining fuel from carburetor then
drain the tank again. Close choke, start and run the
engine until it stops due to lack of fuel.
• Allow engine to cool then remove the spark plug and
pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine
oil into the cylinder through the spark plug hole.
• Store in a dry area, free from dust.
WARNING
Do not store in an enclosure where fuel fumes
may accumulate or reach an open ame or spark.
CAUTION
Do not lend or rent your chain saw without the
Instruction manual and Safety manual.
NOTE
• For future reference, you should keep this Instruction
manual and the Safety manual.
• If this Instruction manual or the Safety manual has
become illegible or is lost, please contact your ECHO
dealer, or go to www.echo-usa.com.
To Next Page
Loading...
Need help?
General
